Hello, everyone, I am your good partner at home, I believe that the partners drink a lot of drinks during the holiday party, right? So how to deal with the empty bottles? Do you throw it away or use it for other purposes?
In fact, if these glass wine bottles are slightly modified, they can still be used, such as throwing cups, pen holders, vases and so on. So how to cut these glass bottles?
Today, let’s make a special tool for bottle cutter. First, I took a piece of wood and sawed it into three parts. Then I cut an M6 hole in two of them. Then I took a stainless steel screw rod and sawed it into two sections. It just became the hole we made. This hole was made for it.
Next, draw a warm mark on these two small boards, saw it off with a saw, put an empty wine bottle on the back mouth, put a glass knife head on it, draw a mark, then turn it on the glass knife head, turn a small hole out, use two small screws to screw it against the black mouth of the board, the knife head should be slightly prominent, remember to tighten it.Then take two butterfly-shaped stainless steel nuts, screw them on the stainless steel screw rod respectively, then put on a piece of wood with buckle mouth, and then screw on two butterfly nuts.
Next, put a stainless steel nut on the screw rod, which is on the board lamp of the glass knife I just installed. Then screw on two stainless steel nuts, use pliers to tighten and fix them, and finally put two stainless steel nuts on the other side of the screw plate of the board without a cut, so that a tool for cutting glass bottles is basically completed, not bad.
Let’s take a wine bottle and measure it first. We find that the distance between the two pieces of wood with grams is a little big. We screw the butterfly nut to adjust it. When it reaches the right position, we tighten the butterfly nut and fix it. Then we push the wooden board without closure inward and use it to support the bottom of the bottle. Then we start to rotate the bottle clockwise with the squeaking sound. The needle will be cut into a circle by the glass knife. The cutting machine must be completed at one go in the process of cutting.Then take the cut bottle to the sink, heat the cut mark with a flamethrower, turn on the tap, pour cold water on it, use the principle of thermal expansion cooling, gently break the bottle with cold water, the bottle is broken at the position of the mark, and the incision stone is tiny.
Then take a thicker rubbing bottle and try it. This bottle is a little tall. Let’s adjust the board to the right position, and then rotate the bottle along the needle. This time, the cut mark looks very obvious. Then take it to the sink and heat it on its mark with the same fire box. While heating, turn the bottle with one hand. In this way, it will be heated more evenly.After heating, pour it with cold water, break it gently with your hand, and it will become a frosted cup. Finally, pack the cup head with sandpaper. What do you guys think of this bottle cutter gadget?
